Notifications
Clear all
0
07/07/2022 9:36 am
Topic starter
Has anyone else had problems printing the battery holder? I've found that it does not sit square on the build plate and the Prusa printer struggles to get it to stick. I've a slightly revised design that has a rx tray on the side facing the winch. Once I'm happy I'll post it here to get any ideas on how we can improve it further.
don't use it is my answer get the battery as low as possible and flat on the floor
2 Answers
0
07/07/2022 2:34 pm
Topic starter
I've just printed out the same item from gcode and its fine. Weird or what.
0
07/07/2022 8:53 pm
Yes, if you use the STL file you have to place the base surface on bed in your slicing software before slicing the part.
