Notifications
Clear all
0
07/07/2022 6:55 pm
Topic starter
Hi I'm not sure what is causing this but it seems to be occurring on the doubled over reinforcing so my thoughts are insufficient cooling. Has anyone else noticed something similar.
0
07/07/2022 7:44 pm
Topic starter
Ok slowed down the print and increased cooling. So far so good.
0
07/07/2022 8:37 pm
Have never seen that before. Try only to slow down the print, avoid using part cooling as it makes the part more brittle. The Gcode provided has no part cooling, only some small parts have layer fan at 10%.
https://www.youtube.com/watch?v=Bl2ESvtBiLo&t=862s
Â
0
07/07/2022 9:26 pm
Topic starter
Thanks - lots to learn